Power for Driver Station

eugenebrooks · #1 10-03-2009, 20:50

Quote:

Originally Posted by esquared

OD is ~0.215"
ID is very roughly 0.080", our dial calipers were too fat to fit inside the barrel.
--Eric

Likely a "type N" power connector, thanks!

Joe Ross · #2 10-03-2009, 20:59

Quote:

Originally Posted by eugenebrooks

Likely a "type N" power connector, thanks!

It's size M. The size is listed on the KOP checklist as 2.1mmx5.5mm.

Speeder · #3 11-03-2009, 01:20

What we did with both the camera and WGA was cut the original power supply wires and use 1/4" insulated spade connectors on the ends. Now we can easily use either the original transformer or wiring on the robot. We'll be doing the same to the DS power cord. After FLR we'll be adding a set of wires from a fused port on the Power Board for the DS.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Driver Station S.O.S.	M. Gildner	Electrical	15	28-11-2009 19:35
Driver Station for Autonomous	shrimp	Control System	5	03-03-2009 17:05
Driver Station	dnrobotics11	Control System	2	18-02-2009 21:35
Driver Station Power at the competition.	Robo640	FRC Control System	3	13-02-2009 16:59
Reading battery power on Driver station.	Digmaster	Electrical	8	31-01-2009 20:09