|
|
|
 Coming up next on Pimp My Ride.....Yo man, here is the real deal. A two-oh-oh-six Segway I-one-eighty, with stock rims, stock fenders, and two 3 horse motors that red-line at twelve point five miles per hour. Get ready, because I'm going pimp this ride! - artdutra04 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
11-03-2009, 10:08
|
|||||
|
|||||
|
Re: unable to connect camera
Try setting your PC to an IP address of 192.168.1.6
Connect the camera via your cross-over cable. Probably reset the camera to it's default factory settings, as Josh suggested, to be sure a network setting isn't messed up. Run "Setup Axis Camera" Then try using Vision Assistant 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| unable to deploy | SL8 | NI LabVIEW | 1 | 17-02-2009 21:02 |
| Directly connect to camera | brianelite | Electrical | 2 | 09-02-2009 00:47 |
| Cannot Connect to Axis Camera Wirelessly | computerish | Technical Discussion | 4 | 11-01-2009 19:19 |
| How do i connect the camera for testing? | naor52 | Programming | 1 | 12-01-2006 01:11 |
Threaded Mode