|
|
|
 No, I've never done 3D programming before, but I'm young and naive, so I still think I can do it. ;) - Ryan M. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| No, I've never done 3D programming before, but I'm young and naive, so I still think I can do it. ;) - Ryan M. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Autonomous help
Coding in LabView. Ok SO we have autonomous code written and teleop written. We are using Main.VI as our startup code on the cRio. Teleop is running correctly when the DS is switched to Teleop Enabled. Here is the problem, autonomous is correctly running on the block diagram on our laptop however the code is not running on the bot when the DS is switched to Auto Enabled.
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Autonomous Help | GunfighterJ | NI LabVIEW | 2 | 10-02-2012 07:06 |
| Autonomous help | csshakka | NI LabVIEW | 3 | 15-02-2009 13:21 |
| autonomous help | jfrank | Programming | 8 | 08-02-2008 10:25 |
| HELP ON Autonomous !!!! | jesusescobar | Programming | 1 | 10-02-2007 20:45 |
| Autonomous Help | mightywombat | Programming | 11 | 07-01-2004 10:45 |
Impossible is just a big word for small men who find it easier to live in the world they've been given than to explore the power they have to change it. Impossible is not a fact. It's an opinion. Impossible is not a declaration. It's a dare Impossible is potential. Impossible is temporary. Impossible is nothing.
Threaded Mode