Saving and Retriving data to the cRio in Labview

Birdlives · #1 15-03-2009, 22:03

I need to save data to the cRio and later load it on to a computer.
I am relatively new to the programming world, so please bear with me, as I have only been using Labview for about a year.
Many thanks

Greg McKaskle · #2 16-03-2009, 07:38

To save it, use file I/O functions, perhaps look at examples if you get stuck.
To retrieve from the computer, I'd use an ftp client. If you don't have a good one, you can type ftp:///10.xx.yy.06 into the address bar of an explorer window. Navigate to the location you saved the files and drag the file back to the PC file system. Just beware of caching with the Windows Explorer based ftp. It usually works, but sometimes shows you stuff that isn't really there.

Greg McKaskle

byteit101 · #3 16-03-2009, 15:18

ftp://
not
ftp:///

Greg McKaskle · #4 16-03-2009, 21:26

Thanks.

Greg McKaskle

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Data delay between Crio and DS	Tom Line	NI LabVIEW	9	17-02-2009 08:40
Saving files on the cRio	Bomberofdoom	NI LabVIEW	8	16-02-2009 08:33
Vista and Labview to CRio	Skyman7	NI LabVIEW	0	13-02-2009 18:42
Capture Data from the cRio	goodsky	Programming	2	13-01-2009 21:27
Students build SEGWAY in 3 months using Labview and the cRIO	neutrino15	Programming	31	27-04-2008 22:08