Gyro interface to software

24-06-2002, 02:50

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Gyro interface to software

Posted by Erik at 03/26/2001 1:08 PM EST

Engineer on team #381, Trenton Tornados, from Trenton High School and Princeton University.

Can someone give me a heads up on how to interface the gyro with software, how to set up a variable to act as the input, is it digital or is it an analog signal, and if so is a simple if statement htat checks to see the value of the analog variable sufficient to use as a conditional starter for some automatic control of the robot? Any help and guidence appreciated.

-engineer forced to program

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SCRRF Design Classes	Redhead Jokes	Southern California Regional Robotics Forum	0	10-07-2003 17:29
which software	Ryan Foley	3D Animation and Competition	5	01-03-2003 23:39
Looking for operator interface... Where is it?	mike325	General Forum	2	07-01-2003 15:28
software software software	archiver	2001	5	24-06-2002 00:21
Have YOU used the gyro chip?	FotoPlasma	Technical Discussion	10	31-01-2002 13:26

All times are GMT -5. The time now is 20:01.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.