|
|
|
 I learned... that I need to learn more. - Erin Rapacki [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I learned... that I need to learn more. - Erin Rapacki [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: problems with velocity readout from encoderget vi
Make sure that the " minimum rate" parameter is not set too high. We scaled our output to ftc/sec, so the default min rate was too big. If your measured rate drops below the min, the output is set to zero, and the "stopped" output goes true. Watch the "stopped" output.
|
|
#2
17-03-2009, 12:11
|
||||||
|
||||||
|
Re: problems with velocity readout from encoderget vi
It sounds like you may have found the bug mentioned here: http://forums.usfirst.org/showpost.p...5&postcount=34
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems undeploying a program from the cRIO | ellisk | Programming | 2 | 29-12-2008 16:21 |
| Gyro problems, crossposted from Electrical | EFastring | Programming | 4 | 05-02-2008 10:16 |
| Problems Using PID for Velocity | Astronouth7303 | Programming | 6 | 10-02-2006 09:00 |
| Digital Caliper as a Digital Readout on Small Mill | sanddrag | Technical Discussion | 9 | 13-10-2005 22:51 |
| Translating pressure sensor readout into actual pressure | Mercutio | Pneumatics | 0 | 13-02-2004 16:29 |
Hybrid Mode
