CIM Reduction? - Chief Delphi

22-03-2009, 21:13

R.C.

2017... Oooh Kill em, Swerve!

AKA: Owner, WestCoast Products

FRC #1323 (MadTown Robotics)

Team Role: Engineer

Join Date: Feb 2008

Rookie Year: 2006

Location: Madera, CA

Posts: 2,184

Re: CIM Reduction?

You could also ream it out on the lathe, depending on which one is more accurate. With the lathe your hole should be concentric. Just another option.

__________________
R.C.
Owner, WestCoast Products || Twitter
MadTown Robotics Team 1323

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors	waialua359	Motors	11	14-12-2007 04:29
Weight Reduction	Rob Colatutto	Technical Discussion	38	20-01-2007 11:34
Quoted picture size reduction	sanddrag	CD Forum Support	1	25-07-2006 19:05
Weight Reduction Help.	Mirza95vx	Technical Discussion	11	07-02-2005 16:03
Gear reduction question	dmellich	Motors	6	25-01-2003 08:54

All times are GMT -5. The time now is 02:49.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.