|
|
|
 that....was more far-fetched than the tennis ball I threw for my dog earlier today... - TeknicllyInsane [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| that....was more far-fetched than the tennis ball I threw for my dog earlier today... - TeknicllyInsane [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#10
30-03-2009, 20:42
|
||||
|
||||
|
Re: Programming toggle switches to DS for different autonomous routines?
If this helps, there is a dipswitch on the cRIO that is readily available for user use (a light too). If you only have two types of autonomous modes, you can use that switch to change modes before each match starts. In LabVIEW, the VIs for getting the switch state and controlling the light are in the driverstation palette, I think. Someplace like that, look around.
Here's a very helpful manual about the cRIO that mentions these things: http://decibel.ni.com/content/docs/DOC-2632 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming Toggle Switches in Labview | seanl | Programming | 1 | 16-02-2009 13:02 |
| Multiple programs/autonomous routines | galewind | Programming | 12 | 09-01-2004 22:25 |
| Autonomous Routines | Powers | Rules/Strategy | 15 | 10-04-2003 10:27 |
| 3 way toggle switch programming | LeadRiccardoT | Programming | 3 | 17-02-2003 02:02 |
| Wiring custom toggle switches into operator interface | DanL | Electrical | 9 | 13-02-2002 17:13 |
Threaded Mode