|
|
|
 Can we just get over this inane lawyering of the rules and get back to building robots?
. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Can we just get over this inane lawyering of the rules and get back to building robots?
. - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Gearbox/reduction for CIM,RS550,RS540
We have some CIM, and RS540/550 motors left over from 2008 and 2009 kits. Interested to use them as future drive motor in the prototype platform. Normally, folks will use some gearbox to reduce the RPM of the motor to make it usable as drive motor. Have any one/team use either chain/sprocket or timing bell/pulley directly to drive the robot successfully. If yes, how and what are combination of sprocket/pulley parts numbers?
Dean Last edited by uid60001 : 03-04-2009 at 15:43. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: VEX High Reduction Gearbox | JVN | Extra Discussion | 40 | 06-07-2009 16:58 |
| CIM Reduction? | excel2474 | Technical Discussion | 8 | 22-03-2009 23:08 |
| CIM motor gearbox | tseres | Motors | 3 | 22-05-2007 22:31 |
| pic: Bike Cim + 56 mm gearbox | NK2007 | Extra Discussion | 7 | 15-01-2007 01:10 |
| Drill Motor Gearbox Reduction Ratios | archiver | 2000 | 3 | 23-06-2002 23:05 |
Threaded Mode