|
|
|
 As part of this test phase, I would expect to see Aidan sleeping on the job for most of the upcoming season. :) - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| As part of this test phase, I would expect to see Aidan sleeping on the job for most of the upcoming season. :) - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
10-04-2009, 16:46
|
|||
|
|||
|
Re: 0.502" Drill bit?
Oh, one last thing. Make sure the pulley, wheel, hub or whatever slides over the shaft before you final broach it. Can't use a straight reamer to open up the hole once it is broached although a spiral one might work if you can find one.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Championship Event - Where the "Random" Match Sorting Really "Shines" | Travis Hoffman | Championship Event | 57 | 19-04-2007 08:06 |
| New NEMO White Papers! "Creating a Killer Packet" and "25 Ways to Sponsor" | Jessica Boucher | Team Organization | 0 | 10-08-2005 10:55 |
| "Thunderbirds" Vs. "Team America" Which one will rule the box office? | Elgin Clock | Chit-Chat | 3 | 07-09-2004 19:53 |
| Leftover 1/2" Drill Motor Mounts | JAlpert | General Forum | 0 | 23-11-2003 20:53 |
| A Summer Event (or, 345 or 502 Horsepower, Take Yer Pick) | archiver | 1999 | 0 | 23-06-2002 23:18 |
Threaded Mode