|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Hi Folks,
I just wanted to show you all my Scorbot setup with some custom conveyor work that I put together using Industrial Flex-link conveyor chain. I've been using several models of the Scorbot series robots for more than five years now, talk about fun. I finally got my controller-A interfaced properly and running very smoothly with ATS ACL software. The Scorbase software for the ER-III controller is ok too, but I prefer using the controller-A ACL software, so on that note the ER-III connected to this controller is essentially a mod to an ER-V robot. My plan is to mod a ER-4PC that I have to an ER-V Plus and run it with the controller-A unit as well. I'm also doing some work with CRS 265 robots, fun fun! Scorbots are Awesome!! -Gerry Here's a few shoots from the building phase. The yet to be moded ER-4PC on the Flex-Link Conveyor table This is my Controller-A unit running ACL software My ER-III robot getting ready to be interfaced to the ACL controller ![]() Some New Flex-Link chain I just got to build a new conveyor table with the Drive unit under the table for Continuous Flow, as compared to the previous model shown above. Last edited by Gerry_TECH : 29-04-2009 at 16:28. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VBA - How to put data in cell with macro? | indieFan | Chit-Chat | 1 | 28-12-2008 21:37 |
| pic: Green Machine Competition - 10 Cell Fuel Cell Stack | Conor Ryan | Extra Discussion | 18 | 04-01-2007 08:09 |
| "Familiar Looking" Table-Top Robotics Project | Vince | Robotics Education and Curriculum | 6 | 21-08-2005 17:28 |
| Scorbot ER 3 Software | Leav | Kit & Additional Hardware | 3 | 22-12-2004 15:42 |
| using SCORBOT for disabled people | kandyuee | Robotics Education and Curriculum | 2 | 16-04-2004 07:31 |