|
square holes
Posted by Ken Patton at 04/30/2001 10:58 PM EST
Engineer on team #65, The Huskie Brigade, from Pontiac Northern High School and GM Powertrain.
In Reply to: What is your favorite method for attaching gears to shafts?
Posted by bill whitley on 04/30/2001 3:51 PM EST:
For tight packaging, we use wire EDM'd square holes. For areas where packaging is not a problem, we use flange mounts.
Ken
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
Welcome to FIRST! You will soon figure out that there is no "exit strategy" from this program. - David Brinza [more] 
Similar Threads
Hybrid Mode
