|
|
|
 It is not your banners that make you nor the trophies that line your walls. It is the willingness to be brave in the face of defeat and compassionate in the winds of victory that create you. - MysterE [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Any ideas?
I'm working on a project were i need to mount a DeWALT 2-speed drill. The application of this drill is for a drive train direct driving a wheel so secure mounting is needed. I took off the case to take a look inside and the case seems to be needed to hold the gearbox together but i will cut the handle off. I have a couple of solutions but I am wondering if anyone else has a better one before I start cause funding is very much limited so I wanted the best and simplest method possible. So anyone with any idea of mounting this it would be much appreciated.
This is the link to the Drill: http://www.canadiantire.ca/AST/brows...4V%2BDrill.jsp |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Any ideas? | ttldomination | FIRST Tech Challenge | 4 | 29-10-2008 11:41 |
| Any Ideas? | Cody Carey | Technical Discussion | 7 | 25-02-2005 19:24 |
| Any Ideas? | Jonathanb | Motors | 3 | 16-04-2003 20:00 |
| any ideas?!?!?!?!?!? | Tyler Olds | 3D Animation and Competition | 0 | 26-11-2002 09:19 |
| got any ideas? | Brandon Martus | Chit-Chat | 4 | 02-09-2001 11:32 |
Threaded Mode