|
|
|
 I never had any doubt; good people who do good quality work will always prosper. - Gary Dillard [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I never had any doubt; good people who do good quality work will always prosper. - Gary Dillard [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Gears for CIM
I am in charge of designing a swerve drive for my team. I am having touble finding a spur gear that has the bore size to direct connect to the CIM's.
What i need it for is a CIM with a spur gear direct connect that goes to a .5" axle with another gear on it. I would like about a 6:1 gear ratio but if larger can be found that would be aswome. Note: the larger gear has to be smaller in diameter than a standard FIRST wheel. So if anybody has a place to buy gears for a cim that would rock. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| Gears for CIMs | Brawler006 | Motors | 5 | 18-01-2004 09:46 |
| Replacement for Bevel Gears? | Greg | Technical Discussion | 3 | 30-03-2003 19:56 |
| Spur Gears for Bosch and FP | archiver | 2001 | 11 | 24-06-2002 03:17 |
| Gears for Chipuahs!!! | dense | Motors | 2 | 16-01-2002 20:41 |
Threaded Mode