Gears for CIM - Chief Delphi

I think the only way I'd die from posting on CD is from my wife killing me. - Koko Ed [more]

		Chief Delphi > Technical > Motors
Gears for CIM

Thread Tools

Rate Thread

Display Modes

30-05-2009, 00:04

Joe_Widen

Registered User

FRC #1675 (The Ultimate Protection Squad)

Team Role: Alumni

Join Date: Jan 2006

Rookie Year: 2005

Location: Milwaukee

Posts: 215

Re: Gears for CIM

I know this doesn't directly apply to your question, but when your designing the crab drive leave like .003" inbetween gears. If you plan for them to mesh perfectly, youll find they grind a bit and dont spin that well.

__________________
Finally in college =]

2009 Midwest Regional Champions - Thanks 111 and 1625

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors	waialua359	Motors	11	14-12-2007 04:29
Gears for CIMs	Brawler006	Motors	5	18-01-2004 09:46
Replacement for Bevel Gears?	Greg	Technical Discussion	3	30-03-2003 19:56
Spur Gears for Bosch and FP	archiver	2001	11	24-06-2002 03:17
Gears for Chipuahs!!!	dense	Motors	2	16-01-2002 20:41

All times are GMT -5. The time now is 22:15.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.