|
Not too hard to do
Posted by Andy Baker at 05/24/2001 11:09 AM EST
Engineer on team #45, TechnoKats, from Kokomo High School and Delphi Automotive Systems.
In Reply to: How in the world..
Posted by Gui Cavalcanti on 05/23/2001 5:09 PM EST:
... but it's hard to explain. We made a circular piece that fastened to the FP motor and clamped on the back of the drill motor. The circular piece had holes in the sides, where we could route the drill motor wires out. Also, these holes would let us see in and check the mechanical connection of the coupling.
Again... it's kinda hard to explain. Once the design is published, you'll see it wasn't that difficult to wire the motors.
Andy B.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
Kudos to you IFI, for your continued support of FIRST and its stated ideals - Racer26 [more] 
24-06-2002, 04:17
Similar Threads
Threaded Mode