|
|
|
 How many programmers does it take to change a light bulb?
None. They'll just say it's a hardware problem. - crafty [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| How many programmers does it take to change a light bulb?
None. They'll just say it's a hardware problem. - crafty [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
17-06-2009, 12:01
|
||||
|
||||
|
Re: Team 2338 swerve drive peer review
After spending the extra time i had on my hands working on the model i completed the model with constraints and motion constraints then put four wheels on a weighted down cart, and applying the appropriate forces. Design simulation, part of autodesk inventor 2010, says that the plats on the side need to be thicker up to 3/16" should do it
 Last edited by BlackBird11891 : 17-06-2009 at 14:06. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Team 1535 Peer Awards | JakeC | Extra Discussion | 9 | 06-03-2009 22:50 |
| team 2338 robot | Creator Mat | Robot Showcase | 1 | 18-02-2009 18:09 |
| pic: Team 108 - LEGO swerve drive | zander_108 | Extra Discussion | 8 | 10-04-2007 22:36 |
| Setting up a peer-to-peer network | Michael Hill | IT / Communications | 7 | 26-07-2006 20:29 |
| Team 312: HeatWave multispeed swerve drive | Stephen Kowski | Robot Showcase | 10 | 08-03-2006 23:48 |
Threaded Mode