AndyMark 4" Dualie Omni Cart video with Kenny Beckwith

Richard Wallace · #1 28-06-2009, 09:24

This is a very nice addition to the AM line-up, Andy.

A few questions: are the rollers identical to those used on other AM omniwheels? How are the roller spindles retained in the black polycarbonate wheel plates? Are the wheel plate halves held together with adhesive?

Andy Baker · #2 28-06-2009, 10:16

Quote:

Originally Posted by Richard

A few questions: are the rollers identical to those used on other AM omniwheels? How are the roller spindles retained in the black polycarbonate wheel plates? Are the wheel plate halves held together with adhesive?

Yes, these are the same black SBR rubber rollers used in the 6" and 8" omni wheels.

The rollers ride on a captured dowel pin.

The wheel plate halves are held together with 6 screws, so the rollers can be replaced.

Thanks for the questions,
Andy

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
AndyMark Coolie Dualie now available	Billfred	General Forum	7	27-12-2006 23:10
Friction coefficients for Omni wheels and Mecanum wheels from AndyMark	Andy Baker	Technical Discussion	11	16-12-2006 19:40
pic: "Omni Grenade" Wheel	D.Fahringer	Extra Discussion	8	11-10-2006 16:05
AndyMark Omni Wheels	Wayne Doenges	Technical Discussion	11	25-01-2006 23:54
pic: "Omni Grenade" Wheel	D.Fahringer	Extra Discussion	20	11-12-2004 13:02