|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: WHAT TO DO WITH LAST YEAR'S FLOOR?!
I would tend to doubt that they'll use regolith again.
My team gave ours away to a local team midway through the buildseason, so we don't have to find anything to do with the extra. Before we gave it away, we were considering printing out big team signs and using the regolith as a backing to keep them from ripping. I think it could make nice sidings for a refridgerator too We actually almost used it for side paneling this year on our robot, but used lexan instead so we could actually see into the robot. It's good matrial because of how flexible it is. Last edited by sgreco : 27-07-2009 at 13:39. |
|
#2
|
|||||
|
|||||
|
Re: WHAT TO DO WITH LAST YEAR'S FLOOR?!
Build a shower so that robo-people don't have to go home at all during build season?
![]() |
|
#3
|
|||
|
|||
|
Re: WHAT TO DO WITH LAST YEAR'S FLOOR?!
I thought everyone just waxed it, put it down on the floor, and
..Guess we're doing it wrong. |
|
#4
|
||||
|
||||
|
Re: WHAT TO DO WITH LAST YEAR'S FLOOR?!
Was never slippery enough. I wanted to get some of those slippy curling shoe pad things and slide around with those.
Keep in mind the stuff's pretty prone to snapping. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Last Year's Gyro | sparrowkc | Rules/Strategy | 4 | 21-01-2008 17:07 |
| Last year's gearbox | MishraArtificer | General Forum | 3 | 10-01-2007 10:57 |
| Interfacing a PC with last year's Robot Controller | punarhero | Technical Discussion | 2 | 21-04-2004 00:05 |
| Last year's motors? | archiver | 2001 | 2 | 24-06-2002 00:33 |
| Last Year's Pneumatics | archiver | 2000 | 3 | 23-06-2002 22:04 |