|
|
|
 You shouldn't have to apologize at all for wanting to have fun. This is supposed to be fun. You shouldn't gauge your level of enjoyment at the event based on your place in the standings. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#6
13-08-2009, 14:22
|
||||
|
||||
|
Re: 6061 aluminum plate??????????
I like online metal's pricing. After shipping that site is only slightly higher than our local supplier but it's hit or miss whether or not we can get a 27' tube from the local supplier site to ours.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best hand tool to use to cut sheet metal (aluminum diamond plate)? | Elgin Clock | Technical Discussion | 22 | 02-10-2008 11:09 |
| ALuminum jig plate - cheap surplus | Dick Linn | Technical Discussion | 0 | 19-12-2007 12:40 |
| 6061 Vs 6063 | Karthik1 | General Forum | 8 | 16-02-2007 19:44 |
| Aluminum Plate | archiver | 2001 | 1 | 24-06-2002 00:03 |
| 1/4" Aluminum Plate | Brian_Lim | Rules/Strategy | 3 | 15-01-2002 18:32 |
Threaded Mode