|
|
|
 ahhhh, for the good old days, when our robots always seemed to come in well under weight instead of well over... :(
. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| ahhhh, for the good old days, when our robots always seemed to come in well under weight instead of well over... :(
. - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#10
13-08-2009, 16:20
|
|||||
|
|||||
|
Re: 6061 aluminum plate??????????
Quote:
Find one near you, ours has a rack of cut offs which you can buy smaller pieces from. Also there really good about cutting smaller sections from longer pieces. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best hand tool to use to cut sheet metal (aluminum diamond plate)? | Elgin Clock | Technical Discussion | 22 | 02-10-2008 11:09 |
| ALuminum jig plate - cheap surplus | Dick Linn | Technical Discussion | 0 | 19-12-2007 12:40 |
| 6061 Vs 6063 | Karthik1 | General Forum | 8 | 16-02-2007 19:44 |
| Aluminum Plate | archiver | 2001 | 1 | 24-06-2002 00:03 |
| 1/4" Aluminum Plate | Brian_Lim | Rules/Strategy | 3 | 15-01-2002 18:32 |
Threaded Mode