|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
||||
|
||||
|
Re: IFI Controller Compiler
EDIT
You must use the MCC18 complier c2.4. Later versions will NOT work. The following instructions assume you have access to either and EasyC install, activated or trial. If you can find a copy of the MCC18 v2.4 installer you can skip copying the folder from EasyC. /EDIT If you have a copy of EasyC installed you'll find the folder "c:\program files\Intelitek\EasyC\mcc18" (this may not be quite right, but its close). This folder contains the MCC18 complier and other required files. Copy that folder to "C:\mcc18". Then install MPLAB IDE from http://www.microchip.com/stellent/id...&part=SW007002. You can find the default source code and documentation at http://www.ifirobotics.com/rc.shtml#Programming. IFI loader, which is used to transfer the program to the robot can also be found on that page. This information is all from memory. I haven't had to work with the IFI system for some time, so there may be small errors in this post. Last edited by EHaskins : 13-08-2009 at 21:26. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IFI Controller Tether protocol | BornaE | Technical Discussion | 7 | 05-05-2009 04:44 |
| IFI Controller Channels - NEED HELP | Kims Robot | Off-Season Events | 3 | 25-02-2008 19:59 |
| Using IFI Controller witout Operator System | 703pascal | Programming | 20 | 16-06-2007 22:10 |
| How much code can an IFI controller handle? | Larry Barello | Programming | 7 | 10-02-2002 19:06 |