Normalizing motor speeds using Arcade Drive in Labview

Intent is determined by those that are doing, not those that are watching. - meaubry [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Normalizing motor speeds using Arcade Drive in Labview

Thread Tools

Rate Thread

Display Modes

22-08-2009, 17:01

rsisk

The GURU Channel

AKA: Richard Sisk

FRC #2493 (Robokong)

Team Role: Mentor

Join Date: Jan 2008

Rookie Year: 2007

Location: Riverside, CA

Posts: 2,748

Re: Normalizing motor speeds using Arcade Drive in Labview

Great feedback, thanks for that Joe. I will definitely check out the friction issues and also grab the manual for some Jaguar tuning. We are using Jaguars on both motors

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FTC]: Using two Hitechnic Motor Controllers in LabView	ZSLAYTER	FIRST Tech Challenge	2	08-03-2009 10:36
Are motor speeds proportional to PWM value?	ellisk	Motors	9	07-02-2009 12:49
Labview questions, using motor and pot as a servo	martin417	NI LabVIEW	7	05-02-2009 16:43
Tracking Servo motor with drive motor in Labview	mbone206	Technical Discussion	5	28-01-2009 17:32
Arcade Drive	Anfony	VEX	4	08-11-2006 19:46

All times are GMT -5. The time now is 10:41.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.