No comms because of router reset?

vivek16 · #1 24-08-2009, 23:51

Hello,

I reset the router and now the robot will not connect. Everything was working perfectly (except for some camera issues) before the reset but I cannot get a connection.

I really hope I can find a solution soon as we have a demo tomorrow and it would be nice to have a working robot.

thanks!, Vivek

skimoose · #2 25-08-2009, 06:35

You probably need to set the router IP address back to the team's IP address. The reset probably set the IP address to the default settings. See Chapter 5 in the control system manual on setting IP addresses. You'll need a computer and a network cable.

Nate Smith · #3 25-08-2009, 09:04

You may have also still had the WPA encryption information in your robot, and someone may have entered this info into the router as well. You'll want to make sure both are set the same, either one way or the other.

vivek16 · #4 25-08-2009, 21:06

Thanks everyone! I did a hard reset of everything and set the proper IP addresses again. That seemed to do the trick.

thanks, Vivek

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
No Comms Issue....	JoeyTNT280	FRC Control System	9	11-06-2009 20:32
I am a geek because...	Joe Ross	Chit-Chat	219	23-02-2008 19:52
things you got to do because of first	Aren_Hill	General Forum	36	07-11-2007 17:07
Camera won't initialize when reset from RC - reset from OI and Power-up works,	krunal	Programming	7	15-01-2007 00:13