|
|
|
 You might want to read...the Manual very carefully.
. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You might want to read...the Manual very carefully.
. - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
28-08-2009, 00:37
|
||||
|
||||
|
Re: Normalizing motor speeds using Arcade Drive in Labview
First off, appreciate all the help.
The problem ended up being a loose electrical connection to the motor and a slight binding problem in the gear box. Once we fixed all that, everything is looking good. Funny how as the team's programming mentor, the first place I turn to is code. I should know better and will check my premises next time. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Using two Hitechnic Motor Controllers in LabView | ZSLAYTER | FIRST Tech Challenge | 2 | 08-03-2009 10:36 |
| Are motor speeds proportional to PWM value? | ellisk | Motors | 9 | 07-02-2009 12:49 |
| Labview questions, using motor and pot as a servo | martin417 | NI LabVIEW | 7 | 05-02-2009 16:43 |
| Tracking Servo motor with drive motor in Labview | mbone206 | Technical Discussion | 5 | 28-01-2009 17:32 |
| Arcade Drive | Anfony | VEX | 4 | 08-11-2006 19:46 |
Threaded Mode