|
|
|
 It is very difficult for a large, inexperienced, impatient group to create order from chaos. - Wayne TenBrink [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It is very difficult for a large, inexperienced, impatient group to create order from chaos. - Wayne TenBrink [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: DIY drive belt
Only a few inches long. I would try to order some. This VCR is old enought I am not sure where to go for parts. I will not be able to get specs until tomorrow night. Grometts might work. I have used them in the past, but they are a little tight.
|
|
#2
29-08-2009, 18:57
|
|||||
|
|||||
|
Re: DIY drive belt
Too bad you can't order online; O-rings or urethane round belting from McMaster would work perfectly here. Urethane round belting can be made to any length with just a knife and a lighter.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Belt drive system | Doctorwho | Technical Discussion | 12 | 17-07-2008 16:00 |
| Belt Drive Pulleys | Ice Berg | Technical Discussion | 8 | 03-06-2008 14:25 |
| Belt drive | esisso | Motors | 7 | 22-01-2008 23:19 |
| Chain drive vs. cogged belt drive(timing belts) | LordBritten | Technical Discussion | 24 | 20-12-2006 23:07 |
| Drive belt | Rachika Garcia | Rules/Strategy | 3 | 10-01-2006 21:19 |
Hybrid Mode
