Driver Station Analog Port Sampling Rate

Tanner · #5 14-09-2009, 18:29

Quote:

Originally Posted by EricVanWyk

What are you looking to do? Maybe we can come up with an alternate solution.

I'm just looking to analyze the frequency/amplitude of a waveform (somewhere from 500hz to 1500hz). Exact use is a secret, but that's all we really are "researching" at this moment.

I was thinking a Arduino would be sufficient, but I'm no electrical guy nor have I ever played with micro-controllers (trust me - I soldered once with our electrical guy, it confirmed we both should stay in our current job positions).

Though the Aruino community say it might not be the best way to do it on that platform (see here).

-Tanner

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wiring an Analog Sensor to Drivers Station	DavidB	Electrical	2	22-02-2009 13:35
Serial port for analog sensors	channan	Electrical	3	10-02-2009 17:35
LabVIEW - Analog inputs from driver station lag?	RedOctober45	NI LabVIEW	1	30-01-2009 10:39
ETH 1 Port on Driver Station	Will_Sica	NI LabVIEW	10	12-01-2009 18:10
Help wiring potentiometer-to-Analog port	kylehager	Electrical	4	17-01-2008 17:28