|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
MaxBotix Sonar Sensor - Help please
Hi,
I'm trying to wire up a MaxBotix MaxSonar EZ4 to an inverting op-amp using the analog output, to turn the 0-0.68v range I'm expecting from the MaxBotix (for my distances) into 3.4-0v. I can get the opamp to work perfectly when using a test voltage, but as soon as I connect the MaxSonar it stops working propertly, and testing the voltages across the Analog output of the maxsonar I no longer get the full range I did when disconnected. Am I missing something obvious? Do I need to add a resistor/capacitor somewhere in the wiring? Many thanks |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview Help: Sonar Sensor | Lucario231 | NI LabVIEW | 4 | 21-01-2009 19:23 |
| Sonar Sensor help | eagleslg | Programming | 9 | 05-05-2008 21:14 |
| Maxbotix Ultrasonic Sensor Help... | manderson5192 | Programming | 9 | 22-02-2008 14:25 |
| Maxbotix Sonar Sensor | DonRotolo | Electrical | 17 | 04-02-2007 12:27 |
| Help with sonar sensor | supertw | Electrical | 3 | 24-01-2006 23:41 |