|
|
|
 Now that football is over... ARE YOU READY FOR SOME ROBOTS?!?! - KelliV [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Now that football is over... ARE YOU READY FOR SOME ROBOTS?!?! - KelliV [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
27-09-2009, 14:54
|
|||
|
|||
|
Re: Inventor 2010
I'm not sure if it's relevant, but there's a belt tool in the level 3 tutorials. Last year in 2009 we had a given chain link and had to make the chain...I'm sure there's an easier way...
|
|
#3
27-09-2009, 19:01
|
||||
|
||||
|
Re: Inventor 2010
There is the chain generator. It creates chain based upon existing, virtual, or created sprockets. I use the old view of Inventor 2010. It is under design accelerator panel. Clicking the assembly panel title allows you to change what panel you are on. Click on triangle next to the v belt design accelerator and select chain generator. From there choose your sprockets, if they are existing, virtual, or component, chain type, and mid plane. Its pretty straight forward.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inventor 2009 vs. 2010 | Nathan | CAD | 17 | 22-03-2010 18:24 |
| 2010 Regional Dates | Sunbun | Regional Competitions | 135 | 01-10-2009 03:13 |
| Help in Inventor 2010 | Rion Atkinson | CAD | 13 | 19-08-2009 14:03 |
| Safety Animation 2010 | mathwiz20 | 3D Animation and Competition | 3 | 12-08-2009 18:25 |
| AutoCad Inventor 2010 | McGurky | CAD | 17 | 16-06-2009 18:14 |
Inventor 2010
Linear Mode
