|
|
|
 FIRST is good for us. It is good for our own Children. Don't give up, even if you are as tired as I am! - Kyle Hughes [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST is good for us. It is good for our own Children. Don't give up, even if you are as tired as I am! - Kyle Hughes [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
[OCCRA]: using Dewalt motors w/o transmission
Are we allowed to use the Dewalt motors with out the Dewalt transmission?
|
|
#2
08-10-2009, 18:21
|
||||||
|
||||||
|
Re: [OCCRA]: using Dewalt motors w/o transmission
Answer:
A reminder that precision machining is not allowed. Taking the Dewalt unit apart and using the motor alone would be a disaster without special equipment to remove the spur gear. Additionally there is no gear that can be pressed on to the motor shaft without precision machining. Answer is NO. If you give us additional information on the HOW and the WHY we may re-consider.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do you put 2 CIM motors into a Dewalt transmission? | jax1488 | Technical Discussion | 17 | 26-05-2008 14:04 |
| pic: Dewalt Transmission 1 | sdcantrell56 | Extra Discussion | 6 | 02-05-2008 23:30 |
| Dewalt Transmission Crisis! | BurnFischer | Motors | 11 | 16-02-2008 00:14 |
| DeWalt Transmission Problem | Kilroy0846 | Motors | 4 | 13-02-2008 09:24 |
| DeWalt Transmission questions | StevenB | Technical Discussion | 22 | 14-02-2007 16:02 |
Linear Mode
