|
|
|
 Everyone is reading way too much into this. The game piece is clearly a bunch of Opahs this year. Problem solved, case closed. Start designing your fish handling robots now. - Ryan Dognaux [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
10-10-2009, 17:40
|
|||
|
|||
|
Re: Pneumatics Code
As for the watchdog, it doesn't matter for us now. We have been programming it that way, and whenever we did try feeding it, it would gives us Watchdog errors.
For the turret.Set(1) and turret.Set(0), I added a Wait in between them for 2 seconds. That should make the solenoid open up for 2 seconds, right? For the pressure switch readings, I guess that means you can't get it to be over 115 PSI? When we hooked it up manually (using 2 batteries and manually sparking them to fire) we fired it at 120 PSI, but we used a manual gauge thing. If I use compressorControl.Start(), does that mean it will never put the pressure above 115? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems integrating CMUCAM code and IFI Default Code | Windward | Programming | 2 | 06-02-2007 16:48 |
| problems using gyro/adc code with camera default code | tanstaafl | Programming | 7 | 22-01-2006 23:09 |
| Pneumatics-Code [and piston output length] | reilly | Programming | 5 | 13-02-2005 11:42 |
| Pneumatics-Code [and piston output length] | reilly | Technical Discussion | 0 | 10-02-2005 12:21 |
| Team THRUST - Kevin's Code and Camera Code Combine | Chris_Elston | Programming | 3 | 31-01-2005 22:28 |
Threaded Mode