|
|
|
 How easy will it be for a driver to control 5-6 different motions at once? Most drivers only have two hands. - Kevin Sevcik [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| How easy will it be for a driver to control 5-6 different motions at once? Most drivers only have two hands. - Kevin Sevcik [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
[OCCRA]: VEX wheelie bar
VGR11 states that we must use only VEX wheels. If we build a "wheelie bar" (a bar that sticks out of the back of the robot to prevent it from tipping over) do we need to put VEX wheels on it? or can we just cover the metal with something to prevent it from damaging the floor?
|
|
#2
11-10-2009, 13:34
|
||||||
|
||||||
|
Re: [OCCRA]: VEX wheelie bar
Official answer:
The rule about wheels is to protect the soft floor. If there is ANY danger to the surface you will be required to remove the object. Yes, we know that arms and such will touch the surface and we will be watching close on this. So.... bottom line is the wheelie bar falls within the same general rules about field damage and the arm.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OCCRA]: 2008 OCCRA VEX Carpet Playing Field - Home Depot | marccenter | OCCRA Programming | 1 | 06-11-2008 09:57 |
| pic: Wheelie Bar | jjjeski | Extra Discussion | 10 | 17-01-2008 13:38 |
| [OCCRA]: The torque bar | wackiejackie7nf | OCCRA | 3 | 16-09-2006 10:23 |
Linear Mode
