|
|
|
 So, apparently I have my own division in nationals going by the search, "elgin clock division". Why was I not told about this? jeesh... - Elgin Clock [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| So, apparently I have my own division in nationals going by the search, "elgin clock division". Why was I not told about this? jeesh... - Elgin Clock [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
15-10-2009, 21:11
|
|||
|
|||
|
Re: mating 2009 rover wheels and sprockets
As a general note, McMaster Carr has a great selection of good-quality screws, at pretty fair prices. You're much better off figuring out what you need and ordering from there, than trying to piece it together with the garbage sold at Home Depot.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mounting Sprockets to the Rover Wheels | Ice Berg | Technical Discussion | 22 | 20-01-2009 00:38 |
| Encoders and Rover Wheels | EncodersRUS | Programming | 14 | 12-01-2009 12:34 |
| Sprockets and wheels don't match up | Astarties | Technical Discussion | 1 | 03-01-2009 17:58 |
| Different sprockets on front and back wheels | neoshaakti | Technical Discussion | 10 | 31-01-2008 17:52 |
| [OCCRA]: question about IFI wheels and sprockets | Russ C | OCCRA Q&A | 1 | 30-09-2006 14:13 |
Threaded Mode