|
|
|
 You enjoy your pepperoni pizza, I'll enjoy my cheese and peppers, and we can both agree that people that like pineapple on their pizza, while strange... are completely entitled to their opinions. - Andrew Schreiber [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
19-10-2009, 12:34
|
|||||
|
|||||
|
Re: Driver station dead
If you find that the DS won't boot properly when connected to its wall wart power supply, about your only course of action would be to try to reprogram it. If it only fails when trying to use the robot battery for power, you might not have a good battery, or you might have a poor power connection.
The WGA (robot radio) power output from the Power Distribution board is perfectly suited to powering the Driver Station. It's up-regulated, so you won't have to worry about momentary low-voltage situations causing an extended loss of control while the DS reboots. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver Station S.O.S. | M. Gildner | Electrical | 15 | 28-11-2009 19:35 |
| driver station | corps | FRC Control System | 5 | 06-08-2009 20:44 |
| Driver Station Question | FRC1612 | Rules/Strategy | 2 | 04-03-2009 15:17 |
| Driver Station | dnrobotics11 | Control System | 2 | 18-02-2009 21:35 |
| Dead Driver Station? | tdeprince | FRC Control System | 3 | 12-02-2009 12:14 |
Threaded Mode