|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: [FTC]: Labview and teleoperated
Hi
Glad the mechanic was usefull to verify robot operation. The templates use a VI called Robot Status, that displays the connection status on the NXT's LCD screen. It shows the battery voltage and the USB or Bluetooth status. Are you using USB or Bluetooth? Is the TeleopBasic program running on the robot? The Controller station will rung the TeleopBasic.vi if you have previously run the Program Chooser to indicate that it is your telop program of choice. What is your display showing? Are both voltages being displayed on the bottom line Does it show OFFLINE or Enabled/Disabled. OFFLINE means that there is no connection to the robot. Enabled/Disabled means you have a connection. Phil. Quote:
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Bluetooth Problem with LabView/FTC Controller Station | James Dowd | FIRST Tech Challenge | 8 | 27-10-2009 10:40 |
| Autonomous and Teleoperated | Technic-R-C | General Forum | 8 | 15-02-2009 16:04 |
| Autonomous and Teleoperated | Technic-R-C | NI LabVIEW | 2 | 06-02-2009 22:19 |
| [FTC]: First problem with FTC and LabView.....? | PhilBot | FIRST Tech Challenge | 5 | 07-11-2008 10:36 |
| First problems with FTC and Labview | PhilBot | National Instruments LabVIEW and Data Acquisition | 0 | 10-09-2008 20:21 |