|
|
|
 When it is so boring and slow on here in the summer it is funny how all of us just jump at something technical. - sanddrag [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| When it is so boring and slow on here in the summer it is funny how all of us just jump at something technical. - sanddrag [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
cRIO system watchdog
We have a bench test setup with a cRIO and last year's control system, excluding the driver station, to get experience with PID and motor control feedback.
The reason we're excluding the driver station is because it will be obsolete in two months, and so training people how to use it is not a good use of time. The problem I'm running into is the PWM, Relay, and Solenoid outputs aren't functioning. Sounds like the watchdog is dead. However, I've opened the watchdog and "feed" it more than twice a second using the WPI "Watchdog" VIs (the timeout is .5 seconds). Perhaps the problem is the system watchdog? How do you make sure the system watchdog is enabled and active? 
|
|
#2
29-10-2009, 00:33
|
||||||
|
||||||
|
Re: cRIO system watchdog
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Watchdog!?!?!?! | NC GEARS | General Forum | 38 | 23-01-2010 08:52 |
| System: Watchdog problems | dboisvert | C/C++ | 7 | 16-02-2009 02:36 |
| System: Watchdog problems | dboisvert | C/C++ | 1 | 15-02-2009 20:12 |
| purchasing buying the 2009 NI cRIO control system | martin417 | FRC Control System | 10 | 29-12-2008 12:31 |
| Nearly Officially Official: cRIO Control System To Be Reused | Billfred | FRC Control System | 64 | 02-11-2008 20:54 |
Linear Mode
