[FTC]: Can anyone lend assistance?

[BLAQmx]

I recommend using the templates. The most essential part of the teleop templates is the communication loop. If you decide against using the templates please use the same communication loop in your code. Great care was taken to optimize this loop to give the greatest possible remote control over the robot.

I recommend beginning your development with your VIs targeted to the computer. This will allow you to utilize the full suite of LabVIEW debugging tools (Highlight execution, single stepping etc). Once you have your code working you should then target the VI to the NXT deploy the code to the brick.

When developing code with the VI targeted to your computer try to stick to the NXT programming palette when adding structures, functions, etc. This will prevent you from writing code with an unsupported function that will throw a 1003 error at compile time.