|
|
|
 I want to see the [game] animation robot with the plunger to pick up balls and the boots that spin to kick them. Could you do that please. It would be very awesome. :D - the man [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#32
19-11-2009, 15:19
|
|||
|
|||
|
Re: how to build a VEX programming module
Now if I have a rs232 to TTL converter that has the following pinouts:
GND RX-> TX<- VCC 3-5v and I'm using a real RS232 pc port. Where do I Connect pins 4-CTS & 6-RTS from the vex programming port? The TTL converter does not have these... Do I connect them directly to the serial port ? Does the TTL converter only need the TX/RX ports to go through it? I dont use a USB to RS232. thanks  Last edited by essence25 : 19-11-2009 at 15:36. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming - Getting Started | Mark McLeod | Programming | 80 | 16-04-2008 23:37 |
| Programming for Vex robots | Jeff K. | Programming | 4 | 13-11-2005 16:40 |
| VEX Robotics | vexrobotics | FIRST Tech Challenge | 8 | 30-03-2005 23:25 |
| OCCRA Teams - where do you build? | Phil 33 | OCCRA | 7 | 28-10-2004 21:41 |
| build new programming (st.louis regional) | nick_champ_2 | Programming | 21 | 23-02-2004 20:55 |
Threaded Mode