Cheap replacement for the Power Distribution Board

EricVanWyk · #1 03-12-2009, 00:22

Just remember to be careful, and have someone with a good nose on hand in case you can't see the smoke plume.

Quote:

Originally Posted by Don Rotolo

Don't forget the 5 volts for the Camera - but you might not need that.

The '09 Analog Breakout and the DSC have the same 12->5V regulator in it that the PD does.

DonRotolo · #2 03-12-2009, 00:25

Quote:

Originally Posted by EricVanWyk

The '09 Analog Breakout and the DSC have the same 12->5V regulator in it that the PD does.

I was thinking a 7805 would be easy enough, but that's a better way.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Power distribution board does not give power to access point	bitsoglass	NI LabVIEW	3	17-02-2009 12:07
Power Distribution Board	BrandonD-1528	Electrical	2	31-01-2009 11:30
Power Distribution Board - Red LEDs on	scherbs17	Electrical	5	22-01-2009 16:04
Power Distribution Board making noises	ravena	Electrical	6	04-01-2009 08:41
5v LED on Power distribution board?	Hadi379	FRC Control System	6	18-12-2008 15:59