|
|
|
 Start building your robot as soon as possible, but not sooner. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Start building your robot as soon as possible, but not sooner. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
[FTC]: Motor and Servo configurations aren't working
Hello Experts,
I have been successful at getting the TeleOpBasic program running with a joystick and my robot - so I know I"m connecting to the NXT brick correctly. However, my robot isn't that basic has servos and I want to have two controllers. I created the attached VI which I think is average...and only moves the motors but somehow I'm not defining the motor configuration correctly... I do see it in the Motor Config Palette (renamed it to WABAT motor config)...but I get NO response connecting it to the NXT and enabling teleop mode. Any ideas? Sorry I couldn't post the VI - its 600kb. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Looking for a working 2008 FTC program | mjgard | FIRST Tech Challenge | 4 | 06-11-2009 11:52 |
| Labview questions, using motor and pot as a servo | martin417 | NI LabVIEW | 7 | 05-02-2009 16:43 |
| [FTC]: [FTC]: RobotC Template Problem (causing an FMS issue) and Potential Servo Prob | PackersFan | FIRST Tech Challenge | 11 | 26-01-2009 21:25 |
| [FTC]: FTC Servo-Motor Problem with Labview | dnhansen | FIRST Tech Challenge | 1 | 26-10-2008 00:43 |
| Robot not doing what we need it to, and printfs aren't working | Bryan Herbst | Programming | 8 | 21-09-2008 20:58 |
Threaded Mode