|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||
|
||||
|
Re: [FTC]: Motor and Servo configurations aren't working
We originally had a similiar problem and it seems that if you're going to use servos you need to have the servo controller be the first controller in the chain and have your chain connected to S1.
When we had the same configuration attatched to S4 it didn't work. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Looking for a working 2008 FTC program | mjgard | FIRST Tech Challenge | 4 | 06-11-2009 11:52 |
| Labview questions, using motor and pot as a servo | martin417 | NI LabVIEW | 7 | 05-02-2009 16:43 |
| [FTC]: [FTC]: RobotC Template Problem (causing an FMS issue) and Potential Servo Prob | PackersFan | FIRST Tech Challenge | 11 | 26-01-2009 21:25 |
| [FTC]: FTC Servo-Motor Problem with Labview | dnhansen | FIRST Tech Challenge | 1 | 26-10-2008 00:43 |
| Robot not doing what we need it to, and printfs aren't working | Bryan Herbst | Programming | 8 | 21-09-2008 20:58 |