|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Re: [FTC]: Motor and Servo configurations aren't working
We have the exact same problem. While trying to fix it we accidentally deleted every file on the NXT, and now we have that same problem with every program we try to run. We have tried all different ports and chaining order, including only a single motor controller and still nothing works. We can't even start the programs directly from the NXT, even a program that has about 5 lines of code, just making the motors go. Well, as I was typing this we re downloaded the firmware onto the NXT and got a motor controller --> servo controller chain working. So try re-downloading firmware.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Looking for a working 2008 FTC program | mjgard | FIRST Tech Challenge | 4 | 06-11-2009 11:52 |
| Labview questions, using motor and pot as a servo | martin417 | NI LabVIEW | 7 | 05-02-2009 16:43 |
| [FTC]: [FTC]: RobotC Template Problem (causing an FMS issue) and Potential Servo Prob | PackersFan | FIRST Tech Challenge | 11 | 26-01-2009 21:25 |
| [FTC]: FTC Servo-Motor Problem with Labview | dnhansen | FIRST Tech Challenge | 1 | 26-10-2008 00:43 |
| Robot not doing what we need it to, and printfs aren't working | Bryan Herbst | Programming | 8 | 21-09-2008 20:58 |