CAN Design Kit

EricVanWyk · #17 09-12-2009, 16:52

Quote:

Originally Posted by AdamHeard

What will sensors be hooked up to?

I was thinking more of box on wheels type practice bots to teach new drivers, so there wouldn't be any sensors. But on second thought, the Jags do have a couple sensor inputs. I'm not saying the 2CAN could replace a full system, but it really does lower minimum the cost bar for partial-bots.

Knowing Mike, I wouldn't be surprised at all if he made a CAN sensor node. Maybe the 2CAN itself will have a few inputs. I haven't gotten the chance to play with these guys yet, but it could happen.

Bear in mind that I tend to believe that more options is never bad, at worst neutral and usually good.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FIRST EMAIL/2009 Kit of Parts Now Available in Autodesk Inventor and Design Comp.	Mark McLeod	FIRST E-Mail Blast Archive	1	06-01-2009 08:16
can we use 06 kit of parts?	Tri_Lam	General Forum	6	16-01-2007 21:25
*FVC Programming Kit/Bundle Kit Upgrade*	KathieK	FIRST Tech Challenge	0	04-12-2006 19:57
pic: Kit Transmission Upgrade kit	Andy Baker	Extra Discussion	17	29-01-2006 01:27
can we use motors from last year's kit?	Amittt	Motors	5	22-01-2006 22:27