|
|
|
 I think the GDC should force us to use steam engines, but the electrically-inclined folks on my team might stop whining if they're given more to work with. - Madison [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#2
10-12-2009, 00:27
|
|||||
|
|||||
|
Re: Hex Broaching?
There is a startup cost to broaching.
You have to buy an Arbor Press and Broaches. We have a 10 ton press from harbor freight and then we bought a 3/8ths and 1/2 hex broach. Arbor was about $200 and then the broaches were donated via sponsor. -RC |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Keyway Broaching | Jonathan W. | Technical Discussion | 3 | 27-01-2008 09:58 |
| Broaching? Easy way? | brennerator | Technical Discussion | 3 | 22-01-2007 23:32 |
| Hex vs. Key | alysume | Technical Discussion | 12 | 31-05-2006 22:37 |
| Hex Couplers | Chris 481 | Technical Discussion | 9 | 03-04-2006 20:49 |
| Non-Standard Broaching | sanddrag | Technical Discussion | 3 | 17-03-2004 11:46 |
Threaded Mode