|
|
|
 If you're destroying game pieces left and right, you're doin' it wrong. - Ian Curtis [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you're destroying game pieces left and right, you're doin' it wrong. - Ian Curtis [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
10-12-2009, 18:41
|
||||
|
||||
|
Re: Drilling through a magnet?
Andrew's just mad that he can't figure out a good method to try, so I'll cut him some slack.
A way to do it might be to try cutting a circle with a plasma cutter. Then punch the middle out. The do'ers of this method will probably need gas masks for noxious fumes if it's a rare-earth magnet, as well as alot of other protective gear for the flying molten magnet. There are probably other issues I can't even imagine as well. Good luck  |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| m magnet? | holty531 | Pneumatics | 2 | 15-02-2008 19:18 |
| pic: The Aluminum Magnet | Travis Hoffman | Extra Discussion | 7 | 07-04-2007 09:50 |
| Advice on drilling through hardened steel? | ThetaDot | Technical Discussion | 10 | 28-02-2004 05:18 |
| Many thanks to Clark Magnet School (696) | Greg Ross | Thanks and/or Congrats | 2 | 04-06-2003 23:20 |
| Latheing an earth magnet | Justin Stiltner | Technical Discussion | 0 | 27-06-2001 22:59 |
Threaded Mode