Problems Switching to WR & Updating DS,cRIO

[Burmeister #279]

[mods feel free to move this if its not where it belongs]

We are trying to get our cRIO to run WindRiver and can't seem to get it working. We have re-imaged it to the "newest" update but set to WindRiver [from LabVIEW] and updated the 2009 driver station to its "newest" update. We then put the default WindRiver program on the cRIO. The cRIO/status light are detecting the disable switch on the driver station and says it has code (solid light) when its enabled, but the driver station says it has no code no matter what we do. I honestly think we probably set it up wrong, but I have no way of knowing because we can't find any of the setup docs from last year! my first request is for a link to those documents so we can figure out if we did it right, and if we didn't we will just redo everything from scratch, but if we did do all of that right, and its not working, does anyone have any idea why it could be broken?

(We understand that the driver station is not being used again next year, but until then we wanted to have some testing ability.)