|
|
|
 So every 3 years robots have to lift robots? There's yet another pattern to consider. :p - ruacubfan2 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| So every 3 years robots have to lift robots? There's yet another pattern to consider. :p - ruacubfan2 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
11-12-2009, 22:23
|
||||
|
||||
|
Re: Problems Switching to WR & Updating DS,cRIO
Link here:
http://www.usfirst.org/roboticsprogr...t.aspx?id=4094 If you imaged it, did you check to make sure you formatted the crio when you did so as well? It's a checkbox on the image window that can bite you if you don't check it. Did you also verify the correct IP? When you redid the firmware on your DS, did you reset team number to the correct one? (This sets IP if I remember right). |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRIO update 3.0 problems | Two-Face | Programming | 3 | 14-02-2009 10:06 |
| MAJOR PROBLEMS AFTER Updating LV and the DS!!?!?!? | Must Be Drama | NI LabVIEW | 1 | 11-02-2009 20:04 |
| cRIO Problems | computerboi1503 | C/C++ | 7 | 11-01-2009 09:35 |
| updating firmware on crio | nickmagus | Programming | 16 | 17-12-2008 16:58 |
| Problems with Updating VEX Controller Master Code | tinderfitles | VEX | 3 | 20-11-2006 17:16 |
Threaded Mode