|
|
|
 Didn't you know, I can be in two places at once? - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Didn't you know, I can be in two places at once? - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
[FTC]: Autonomous Deployment Error "1003"
Hi there, everyone.
When I'm deploying auton code to the robot, it has an error called Error 1003. "The VI is not executable. Mostly likely the VI is broken or one of its subVIs cannot be located Select <b>File>>Open</b> to open the VI and then verify that you are able to run it. Has anyone else had this problem? It also has the same problem with deploying the basic template code as well. However, this error does not occur when deploying Teleop code, basic template or modified. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Issue with POV on LabVIEW "FTC Read Controler.vi" | MattSr | FIRST Tech Challenge | 0 | 01-11-2009 18:56 |
| error : "There were linking errors!"....help please | ProgrammerMike | Programming | 3 | 21-02-2008 08:59 |
| MPLAB 8.0 error "Can not fit section" | billbo911 | Programming | 7 | 20-02-2008 15:26 |
| Screenshot of "code not understood" or similar error needed! | Elgin Clock | Programming | 3 | 17-02-2006 22:06 |
| Program error - "can not fit the section" | miketwalker | Programming | 9 | 20-02-2005 01:21 |
Threaded Mode