|
|
|
 Remember that though we come from different backgrounds and x, y, z, we are all on each other's side. We want people to love STEM, and think FIRST is a great tool to fulfill that desire. - PayneTrain [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
22-12-2009, 18:11
|
|||
|
|||
|
Re: G Code with a Mill
I got bored, so I decided to write this up, hopefully once our mill gets working, I can try it on a wax block.
http://img707.imageshack.us/img707/3061/diamonds.jpg You can't see it in the picture, but the cuts are different depths...The inner-most circle is the highest, and then each one outside it descends by .25".  I have a quick question about it, will the cuts be too close, and overlap each other? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drill/Mill or Lathe/Mill attachment for small shop area | Coach Norm | General Forum | 22 | 16-09-2009 15:59 |
| [FTC]: Problem with Code or Problem with Bluetooth? | VeedotJaydot | FIRST Tech Challenge | 3 | 27-01-2009 18:22 |
| pic: Me with our mill | Lowfategg | Extra Discussion | 1 | 10-01-2009 15:49 |
| problems using gyro/adc code with camera default code | tanstaafl | Programming | 7 | 22-01-2006 23:09 |
Threaded Mode