|
|
|
 Building a 'bot is kinda like washing your hair, but instead of "rinse, lather, repeat"... you should "engineer, test, repeat". - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Building a 'bot is kinda like washing your hair, but instead of "rinse, lather, repeat"... you should "engineer, test, repeat". - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#2
01-01-2010, 12:55 PM
|
||||
|
||||
|
Re: ofstream (standard C++ file output) not working
Try calling Priv_SetWriteFileAllowed(1) in the constructor.
I've never used ofstream on the cRIO, but I've gotten C-style file I/O to work (FILE*, fopen(), fwrite(), etc.). 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| p2 not working? | Lone_Wolf92c | Programming | 5 | 02-22-2008 08:49 AM |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 02-18-2008 06:11 AM |
| Beware - transmission output shaft is not 5/8"! | jskene | Kit & Additional Hardware | 30 | 02-13-2006 02:01 PM |
| Drive() Not a Standard Toolset in EasyC? | Chris_Elston | Programming | 3 | 02-08-2006 09:01 AM |
| Beware - transmission output shaft is not 5/8"! | jskene | Technical Discussion | 3 | 01-19-2006 02:24 PM |
Threaded Mode